View source for Setting up WAN as LAN

<p style="color:red">The information on this page is updated in accordance with the [https://wiki.teltonika-networks.com/view/FW_%26_SDK_Downloads'''00.07.6'''] firmware version .</p>

==Introduction==
This article provides a guide on how to configure WAN port as LAN. These configurations are specifically made for RUTOS devices.


==Alternative 1==

Set your WebUI to '''Basic Mode''':
[[File:Networking device configuration example webui basic mode v1.png|border|center|class=tlt-border|1000x100px]]

Navigate to '''Network → LAN → edit LAN''' the instance:
[[File:Networking device configuration example lan edit interface v1.png|border|center|class=tlt-border|1000x100px]]

Once there, '''enable the Use WAN port as LAN''':
[[File:Networking device configuration example lan enable wan v1.png|border|center|class=tlt-border|1000x265px]]

==Alternative 2==

Enable the '''ADVANCED mode''' on the WebUI . This will allow you to choose from a larger variety of settings:
[[File:Networking device configuration example webui advance mode v1.png|border|center|class=tlt-border|1000x100px]]

Navigate to '''Network →  Interfaces →  General''' and '''disable WAN and WAN6''' interfaces:
[[File:Networking device configuration example wan disable wan v1.png|border|center|class=tlt-border|1000x173px]]

Click on '''edit the WAN''' interface and once a new window pops-up '''go to''' '''Physical settings'''. There, under the '''Interface''' '''add -- No interface --''':
[[File:Networking device configuration example wan wan interface v1.png|border|center|class=tlt-border|1000x465px]]

Click on '''edit the WAN6''' interface and once a new window pops-up '''go to''' '''Physical settings'''. There, under the '''Interface''' '''add -- No interface --''':
[[File:Networking device configuration example wan wan6 interface v1.png|border|center|class=tlt-border|1000x465px]]

Click on '''edit the LAN''' interface and once a new window pops-up '''go to''' '''Physical settings'''. There, under the '''Interface''' '''add eth1''':
[[File:Networking device configuration example lan lan interface v1.png|border|center|class=tlt-border|1000x465px]]

==Test the configuration==
At this point, WAN port should work as LAN. Go ahead and try to swap from your to current port to WAN, you should be able to ping the router.
[[File:Pings useful.png|border|center|class=tlt-border|734x232px]]
[[Category:LAN]]