View source for Template:Netoworking rut configuration example cisco gre

==Introduction==

Generic Routing Encapsulation (GRE) is a tunneling protocol that can encapsulate a wide variety of network layer protocols inside virtual point-to-point links over an Internet Protocol network.

This article provides an extensive configuration example with details on how to create a tunnel connection between two GRE Tunnel instances, one of which is configured on RUTxxx router and the second one on Cisco device.

==Prerequisites==

You will need:

* One RUTxxx router
* One Cisco router (this configuration example was created using Cisco RV340W)
* A PC to configure the routers
* Both routers must have a Public Static or Public Dynamic IP addresses

==Configuration scheme==


[[File:Networking_rutxxx_configuration_example_gre_topology_v2.png|border|class=tlt-border|1100x1100px]]

==RUT configuration==


Connect to router's '''WebUI''', go to '''Services > VPN > GRE Tunnel'''. Enter a name for your GRE instance, click '''ADD''' and when instance appears in '''GRE Configuration''' field, click '''Edit'''. 

[[File:Networking_rutxxx_configuration_example_gre_instance_v1.png|border|class=tlt-border]]

Then apply the configuration presented below. 

[[File:Networking_rutxxx_configuration_example_rut_settings_v1.png|border|class=tlt-border]]

#'''Enable''' instance.
#Select '''Tunnel source''' (select your WAN interface).
#Enter '''Remote endpoint IP address''' (Cisco WAN IP).
#Set '''MTU''' to '''1440'''.
#Write '''Local GRE interface IP address''' (create GRE tunnel IP address or just use the same as in the example).
#Write '''Local GRE interface netmask''' (create GRE tunnel netmask or just use the same as in the example)
#Leave everything else as default and click '''Save'''.

==Cisco configuration==

Connect to router's '''WebUI''', go to '''VPN > GRE Tunnel''' and apply the following configuration.

[[File:Networking_rutxxx_configuration_example_cisco_settings_v1.png|border|class=tlt-border]]

#Write '''GRE Tunnel Description''' (anything you want).
#Select '''Source''' (select your WAN interface).
#Enter '''Destination''' (RUT WAN IP).
#Write '''IP Address Of GRE Tunnel''' (create GRE tunnel IP address or just use the same as in the example).
#Write '''Subnet Mask''' (create GRE tunnel netmask or just use the same as in the example).
#Set '''MTU''' to '''1440'''.
#Leave everything else as default and save settings.

==Testing configuration==

If you've followed all the steps presented above, your configuration should be finished. But as with any other configuration, it is always wise to test the setup in order to make sure that it works properly. In order to test the GRE Tunnel connection, login to RUT WebUI and go to '''Services → CLI'''. Login with user name: '''root''' and the router's admin password. From there you should then be able to '''ping''' the opposite instance's virtual IP address. To use a ping command, type '''ping <ip_address>''' and press the "Enter" key on your keyboard:

[[File:Networking_rutxxx_configuration_example_test_v1.png|border|class=tlt-border]]

If the ping requests are successful, congratulations, your setup works! If not, we suggest that you review all steps once more.