Line 22: |
Line 22: |
| [[File:Modbusupdategateway1.png|1000px|border|class=tlt-border]] | | [[File:Modbusupdategateway1.png|1000px|border|class=tlt-border]] |
| | | |
− | * In the configuration section, press '''Enable''' to enable the serial interface
| + | A new window will open, where the device should be configured according to these steps: |
− | * In the Serial '''Type''' section, select '''Modbus gateway'''. ////editable
| |
− | You may need to change configuration depending on your needs, just make sure that identical settings are set here and in RTU simulator: Baud rate, data bits, parity, stop bits, flow control
| |
− | | |
− | [[File:Navigateandenable.png|border|class=tlt-border]]
| |
− | | |
− | This will expand more customization options:
| |
| | | |
| + | * Press '''Enable''' to enable the serial interface |
| * '''Listening IP''' – IP interface on which you are listening for incoming connections (input 0.0.0.0 to listen on any IP address) | | * '''Listening IP''' – IP interface on which you are listening for incoming connections (input 0.0.0.0 to listen on any IP address) |
| * '''Port''' – Port number for Modbus gateway (default port is 502) | | * '''Port''' – Port number for Modbus gateway (default port is 502) |
| * '''Slave ID''' configuration type – User defined or obtained from TCP | | * '''Slave ID''' configuration type – User defined or obtained from TCP |
| * '''Slave ID''' – preconfigured Slave ID number | | * '''Slave ID''' – preconfigured Slave ID number |
| + | |
| + | You may need to change configuration depending on your needs, just make sure that identical settings are set here and in RTU simulator: Baud rate, data bits, parity, stop bits, flow control |
| + | |
| + | [[File:Navigateandenable.png|border|class=tlt-border]] |
| | | |
| [[File:Moreconfigurationoptions.png|border|class=tlt-border]] | | [[File:Moreconfigurationoptions.png|border|class=tlt-border]] |
| | | |
− | In IP filter options on the serial configuration page, add IP addresses that will be allowed to reach your Modbus gateway (input 0.0.0.0/0 to allow any IP address). | + | In IP filter options on the bottom of the page, add IP addresses that will be allowed to reach your Modbus gateway (input 0.0.0.0/0 to allow any IP address). |
| | | |
| [[File:Ipfilter1.png|border|class=tlt-border]] | | [[File:Ipfilter1.png|border|class=tlt-border]] |