Line 20: |
Line 20: |
| Configure serial port communication parameters in the <b>Serial Device Configuration</b> section. | | Configure serial port communication parameters in the <b>Serial Device Configuration</b> section. |
| | | |
− | [[File:Networking_rutos_manual_serial_utilities_over_ip_serial_default_{{{default}}}_v2.png|border|class=tlt-border]] | + | [[File:Networking_rutos_manual_serial_utilities_over_ip_serial_default_mbus_v1.png|border|class=tlt-border]] |
| | | |
| <table class="nd-mantable"> | | <table class="nd-mantable"> |
Line 570: |
Line 570: |
| Configure serial port communication parameters in the <b>Serial Device Configuration</b> section. | | Configure serial port communication parameters in the <b>Serial Device Configuration</b> section. |
| | | |
− | [[File:Networking_rutos_manual_serial_utilities_over_ip_serial_default_{{{default}}}_v1.png|border|class=tlt-border]] | + | [[File:Networking_rutos_manual_serial_utilities_over_ip_serial_default_{{{default}}}_v2.png|border|class=tlt-border]] |
| | | |
| <table class="nd-mantable"> | | <table class="nd-mantable"> |
Line 633: |
Line 633: |
| <td>off {{!}} on; default: <b>off</b></td> | | <td>off {{!}} on; default: <b>off</b></td> |
| <td>Turns Full Duplex mode on or off. This option is available only on the RS485 device.</td> | | <td>Turns Full Duplex mode on or off. This option is available only on the RS485 device.</td> |
| + | </tr>|}}{{#ifeq: {{{rs232}}} | 1 | |
| + | <tr> |
| + | <td><span style="color: green;">RS232:</span> Echo</td> |
| + | <td>off {{!}} on; default: <b>off</b></td> |
| + | <td> Enable serial device echo. This option is available only on the RS232 device.</td> |
| </tr>|}} | | </tr>|}} |
| + | |
| + | |
| </table> | | </table> |
| | | |