403
edits
Changes
VXLAN Configuration Example Lukas Demo (view source)
Revision as of 11:46, 20 September 2024
, 20 September→RUT1 WAN configuration
#Select your preferable '''IPv4 netmask'''
#Select your preferable '''IPv4 netmask'''
# Click Save & Apply twice
# Click Save & Apply twice
[[File:Vxlan_over_wired_wan_settings_rut1.png|border|class=tlt-border]]
===RUT1 WAN configuration===
'''RUT2:'''[[File:Vxlan over wired wan settings rut2.png|border|class=tlt-border]]
Navigate to the '''Network > WAN''' section in the WebUI, then click the '''Edit''' button for the wired WAN interface.
[[File:Vxlan_over_wan_config_rut1_wan_p1.png|border|class=tlt-border]]
Configuration window will open. Adjust following:
#Ensure interface is '''Enabled'''
#Change Protocol to '''Static'''
#Enter Ipv4 address for communication in this Wired WAN network
#Select your preferable '''IPv4 netmask'''
# Click Save & Apply twice
[[File:Vxlan over wired wan settings rut2.png|border|class=tlt-border]]
==Configuring VXLAN over 2 Public IP addresses==
==Configuring VXLAN over 2 Public IP addresses==