31,703
edits
Changes
RUT955 Current Measurement with Analog Input (view source)
Revision as of 13:12, 12 June 2020
, 13:12, 12 June 2020Created page with "If you want to measure the current with RUT955 you need to connect a resistor as shown in the picture below. Note that voltage on pin 9 must never exceed 24V. File:Rut955 a..."
If you want to measure the current with RUT955 you need to connect a resistor as shown in the picture below. Note that voltage on pin 9 must never exceed 24V.
[[File:Rut955 analog input current measurement.png]]
Configure resistor value and analog input name in the router's WebUI (see [[RUT955 Input/Output#Custom_Labels|here]]).
This is commonly used with 4-20mA standard sensors. If your sensor has linear characteristics, you can also configure a sensor slope and offset to directly get measured values.
[[Category:RUT955 Hardware Application Examples]]
[[File:Rut955 analog input current measurement.png]]
Configure resistor value and analog input name in the router's WebUI (see [[RUT955 Input/Output#Custom_Labels|here]]).
This is commonly used with 4-20mA standard sensors. If your sensor has linear characteristics, you can also configure a sensor slope and offset to directly get measured values.
[[Category:RUT955 Hardware Application Examples]]