Line 182: |
Line 182: |
| <tr> | | <tr> |
| <td>Use gateway metric</td> | | <td>Use gateway metric</td> |
− | <td>integer; default: <b>none</b></td> | + | <td>integer; default: <b>0</b></td> |
| <td>A metric specifies the priority of the gateway. The lower the metric, the higher the priority (0 for highest priority).</td> | | <td>A metric specifies the priority of the gateway. The lower the metric, the higher the priority (0 for highest priority).</td> |
| </tr> | | </tr> |
Line 217: |
Line 217: |
| <tr> | | <tr> |
| <td>Use gateway metric</td> | | <td>Use gateway metric</td> |
− | <td>integer; default: <b>none</b></td> | + | <td>integer; default: <b>0</b></td> |
| <td>A metric specifies the priority of the gateway. The lower the metric, the higher the priority (0 for highest priority).</td> | | <td>A metric specifies the priority of the gateway. The lower the metric, the higher the priority (0 for highest priority).</td> |
| </tr> | | </tr> |
Line 275: |
Line 275: |
| <b>Advanced Settings</b> information for <i>PPPoE</i> protocol is provided in the table below. | | <b>Advanced Settings</b> information for <i>PPPoE</i> protocol is provided in the table below. |
| | | |
− | [[File:Networking_rutos_manual_wan_wan_configuration_advanced_settings_pppoe_v1.png|border|class=tlt-border]] | + | [[File:Networking_rutos_manual_wan_wan_configuration_advanced_settings_pppoe.png|border|class=tlt-border]] |
| | | |
| <table class="nd-mantable"> | | <table class="nd-mantable"> |
Line 287: |
Line 287: |
| <td>Automatic <nowiki>|</nowiki> Disabled <nowiki>|</nowiki> Manual; default: <b>Automatic</b></td> | | <td>Automatic <nowiki>|</nowiki> Disabled <nowiki>|</nowiki> Manual; default: <b>Automatic</b></td> |
| <td>Defines behaviour for obtaining an IPv6 address.</td> | | <td>Defines behaviour for obtaining an IPv6 address.</td> |
| + | </tr> |
| + | <tr> |
| + | <td>Use default gateway</td> |
| + | <td>off <nowiki>|</nowiki> on; default: <b>on</b></td> |
| + | <td>When enabled, add a default route for this interface.</td> |
| + | </tr> |
| + | <tr> |
| + | <td>Use gateway metric</td> |
| + | <td>integer; default: <b>0</b></td> |
| + | <td>A metric specifies the priority of the gateway. The lower the metric, the higher the priority (0 for highest priority).</td> |
| </tr> | | </tr> |
| <tr> | | <tr> |