Line 1: |
Line 1: |
− | da³vid embedded data GmbH is a cloud based, real-time IoT management gateway. More information can be found here - http://www.embedded-data.de/produkt_david | + | The name da³vid stands for datapoint acquisition analysis and visualisation and is developed by "embedded data GmbH" in Germany. |
| + | da³vid is a cloud and/or edge based, real-time IoT management software. |
| + | More information can be found here - https://www.embedded-data.de/produkt_david |
| | | |
| __TOC__ | | __TOC__ |
| ==Introduction== | | ==Introduction== |
| | | |
− | This article contains instructions on how to do a basic setup and configuration with a Teltonika device in order to connect to your da³vid embedded data gateway. | + | This article contains instructions on how to do a basic setup and configuration with a Teltonika device in order to connect to da³vid. |
| | | |
| ==Prerequisites== | | ==Prerequisites== |
Line 11: |
Line 13: |
| | | |
| *A Teltonika device (RUT or TRB) with MODBUS support and internet connection | | *A Teltonika device (RUT or TRB) with MODBUS support and internet connection |
− | *A da³vid embedded data GmbH gateway | + | *A Embedded data GmbH da³vid software and license |
| | | |
| ==Configuring the device== | | ==Configuring the device== |
Line 19: |
Line 21: |
| }} | | }} |
| | | |
− | Before you connect the device to the gateway, you must first enable MODBUS by following these steps: | + | Before you connect the device to da³vid, you must first enable MODBUS by following these steps: |
| | | |
| <ol> | | <ol> |
Line 32: |
Line 34: |
| [[File:Networking_rutos_configuration_examples_david_embedded_data_modbus.png|border|class=tlt-border]] | | [[File:Networking_rutos_configuration_examples_david_embedded_data_modbus.png|border|class=tlt-border]] |
| | | |
− | ==Configuring the da³vid embedded data GmbH gateway== | + | ==Configuring da³vid== |
| | | |
| Once logged into the portal, first add a new station. | | Once logged into the portal, first add a new station. |
Line 127: |
Line 129: |
| [[File:Networking_rutos_configuration_examples_david_embedded_data_11.png|border|class=tlt-border]] | | [[File:Networking_rutos_configuration_examples_david_embedded_data_11.png|border|class=tlt-border]] |
| | | |
− | The device should be connected to da³vid embedded data GmbH gateway. To do a simple check, you can try to pull some data from the device following the steps below. | + | The device should be connected to da³vid. To do a simple check, you can try to pull some data from the device following the steps below. |
| | | |
| ===Configuring information output=== | | ===Configuring information output=== |