Jump to content

Da³vid configuration example: Difference between revisions

no edit summary
No edit summary
No edit summary
(3 intermediate revisions by the same user not shown)
Line 1: Line 1:
{{DISPLAYTITLE:da³vid configuration example}}
da³vid embedded data GmbH is a cloud based, real-time IoT management gateway. More information can be found here - http://www.embedded-data.de/produkt_david
 
The name da³vid stands for datapoint acquisition analysis and visualisation and is developed by "embedded data GmbH" in Germany.
da³vid is a cloud and/or edge based, real-time IoT management software.
More information can be found here - https://www.embedded-data.de/produkt_david
 
[[File:Da3vid.png|right|300px]]


__TOC__
__TOC__
==Introduction==
==Introduction==


This article contains instructions on how to do a basic setup and configuration with a Teltonika device in order to connect to da³vid.
This article contains instructions on how to do a basic setup and configuration with a Teltonika device in order to connect to your da³vid embedded data gateway.


==Prerequisites==
==Prerequisites==
Line 17: Line 11:


*A Teltonika device (RUT or TRB) with MODBUS support and internet connection
*A Teltonika device (RUT or TRB) with MODBUS support and internet connection
*A Embedded data GmbH da³vid software and license
*A da³vid embedded data GmbH gateway


==Configuring the device==
==Configuring the device==
Line 25: Line 19:
}}
}}


Before you connect the device to da³vid, you must first enable MODBUS by following these steps:
Before you connect the device to the gateway, you must first enable MODBUS by following these steps:


<ol>
<ol>
Line 38: Line 32:
[[File:Networking_rutos_configuration_examples_david_embedded_data_modbus.png|border|class=tlt-border]]
[[File:Networking_rutos_configuration_examples_david_embedded_data_modbus.png|border|class=tlt-border]]


==Configuring da³vid==
==Configuring the da³vid embedded data GmbH gateway==


Once logged into the portal, first add a new station.
Once logged into the portal, first add a new station.
Line 133: Line 127:
[[File:Networking_rutos_configuration_examples_david_embedded_data_11.png|border|class=tlt-border]]
[[File:Networking_rutos_configuration_examples_david_embedded_data_11.png|border|class=tlt-border]]


The device should be connected to da³vid. To do a simple check, you can try to pull some data from the device following the steps below.
The device should be connected to da³vid embedded data GmbH gateway. To do a simple check, you can try to pull some data from the device following the steps below.


===Configuring information output===
===Configuring information output===