Jump to content

RUTX12 Traffic control with Firewall WANzone Splitting: Difference between revisions

no edit summary
No edit summary
No edit summary
Line 12: Line 12:
==Preparation==
==Preparation==


* Prepare RUTX12, power up the device, insert two sim cards, check that both are active and working. SIM1, SIM2, PWR and signal strength indicators should light up.
* Prepare RUTX11, power up the device, insert two sim cards, check that both are active and working. SIM1, SIM2, PWR, and signal strength indicators should light up.
* Access the router through WEBUI, go to Network -> Interfaces, make sure that one or the other mobile interference is running MOB1S1A1 or MOB2S1A1 (Status = Running). You should be able to see their Ip addresses.
* Access the router through WEBUI, go to <b>Network -> Interfaces</b>, and make sure that one or the other mobile interference is running MOB1S1A1 or MOB2S1A1 (Status = Running). You should be able to see the IP address assigned to it. In addition, it is recommended to perform connectivity checking by using the ping utility.
* Make sure that you have ADVANCED mode enabled. This will allow you to choose from a larger variety of settings.
* Make sure that you have ADVANCED mode enabled. This will allow you to choose from a larger variety of settings.