65
edits
Changes
802.11r WiFi roaming configuration example (view source)
Revision as of 09:13, 26 September 2024
, 26 Septemberno edit summary
The single AP should now be visible on your WiFi devices (an iOS phone is used in this example).
The single AP should now be visible on your WiFi devices (an iOS phone is used in this example).
[[File:Networking roaming test outcome1 v1.jpg|600px|center|border|class=tlt-border]]
[[File:Networking roaming test outcome1 v1.jpg|600px|center|border|class=tlt-border]]
Use copper connect to gateway router, login webUI navigate to '''System → Maintenance → CLI'''. Open '''CLI''' then login by username root and login password.
Do the following steps to check the result.
<ol>
<li>Stand close to Router 2 or Router 3.</li>
<li>Connect to SSID '''WiFi_Roaming'''</li>
<li>Check if the connected devices are showed on wireless clients page. ('''Staus → Wireless → Interfaces''')</li>
<li>Reboot the router 2 or router 3 (Simulate the devices is offline)</li>
<li>Check the gateway router's CLI, the log will show fast transit completed, do not start 4-way handshake.</li>
</ol>
[[File:Networking webui cli test outcome2 v1.png|1000px|border|class=tlt-border]]
