489
edits
Changes
Load Balancing Rules/Policies examples (view source)
Revision as of 10:52, 13 December 2022
, 10:52, 13 December 2022no edit summary
Here we will not be creating new Policies since we already did that on the '''LAN2''' configuration.
Here we will not be creating new Policies since we already did that on the '''LAN2''' configuration.
After setting everything up Save the configuration.
After setting everything up Save the configuration. And after that '''Enable''' the Load Balancing for '''mob1s1a1''' and '''mob1s2a1''' interfaces.
For RUTX12 the configuration is finished, if you are not planning to configure another device (with one modem) skip to the '''Testing the Configuration''' section.
==Configurating Device with one modem==
In this section, we will configure a device unlike '''RUTX12''' with one modem. We will configure all of the traffic from the '''LAN1''' port to go through '''SIM1''' and all of the traffic from the '''LAN2''' port will go through WiFi WAN (you can use regular Wired WAN instead).
Once again we will start the configuration by '''configuring''' '''LAN2''' port traffic, keep in mind that the '''LAN2''' port is configurated as VLAN 192.168.3.0/24.
===LAN2 configuration===
