Line 47: |
Line 47: |
| To test out this functionality you can use two PCs: one running a Modbus Master simulator and the other running a Modbus PLC simulator, acting as a Modbus slave. Follow these steps to configure this testing scenario: | | To test out this functionality you can use two PCs: one running a Modbus Master simulator and the other running a Modbus PLC simulator, acting as a Modbus slave. Follow these steps to configure this testing scenario: |
| | | |
− | * Connect PC1 to RUT955 RS232 port. | + | * Connect PC1 to RUT955 RS232 port |
− | * Connect PC2 to RUT955 Ethernet LAN port. | + | * Connect PC2 to RUT955 Ethernet LAN port |
| | | |
| '''Modbus RTU setup:''' | | '''Modbus RTU setup:''' |
| | | |
− | * On PC1, run the '''ModRSsim2''' application. | + | * On PC1, run the '''ModRSsim2''' application |
− | * In the '''Prot:''' section select '''Modbus RS-232'''. | + | * In the '''Prot:''' section select '''Modbus RS-232''' |
| | | |
| [[File:Rs232modeplc.png|border|class=tlt-border]] | | [[File:Rs232modeplc.png|border|class=tlt-border]] |
| | | |
− | * In the menu in the top right corner, select '''Setup communication Serial or TCP/IP port'''. | + | * In the menu in the top right corner, select '''Setup communication Serial or TCP/IP port''' |
| | | |
| [[File:Setupbuttonrs232.png|border|class=tlt-border]] | | [[File:Setupbuttonrs232.png|border|class=tlt-border]] |
Line 68: |
Line 68: |
| ---- | | ---- |
| | | |
− | * On the PC2, run the '''QModMaster''' application. | + | * On the PC2, run the '''QModMaster''' application |
− | * Select Modbus Mode: '''TCP'''. | + | * Select Modbus Mode: '''TCP''' |
| | | |
| [[File:Modetcpmaster.png|border|class=tlt-border]] | | [[File:Modetcpmaster.png|border|class=tlt-border]] |
| | | |
− | * Navigate to '''Options -> Modbus TCP settings''' to configure TCP connection. Input Slave IP and TCP Port. | + | * Navigate to '''Options -> Modbus TCP settings''' to configure TCP connection. Input Slave IP and TCP Port |
| | | |
| [[File:Mastertcpsettings.png|border|class=tlt-border]] | | [[File:Mastertcpsettings.png|border|class=tlt-border]] |
| | | |
− | * To establish connection navigate to '''Commands -> Connect'''. | + | * To establish connection navigate to '''Commands -> Connect''' |
| | | |
| [[File:ConnectbuttonRTU.png|border|class=tlt-border]] | | [[File:ConnectbuttonRTU.png|border|class=tlt-border]] |
Line 96: |
Line 96: |
| | | |
| If the data is displayed correctly, congratulations, the configuration works! If not, I advise to follow these steps once again. | | If the data is displayed correctly, congratulations, the configuration works! If not, I advise to follow these steps once again. |
| + | |
| + | ==Summary== |