510
edits
Changes
Data transfer from Modbus TCP to Modbus RTU Gateway (view source)
Revision as of 15:55, 8 February 2023
, 15:55, 8 February 2023→Configuring the router
* '''Slave ID''' – preconfigured Slave ID number
* '''Slave ID''' – preconfigured Slave ID number
You may need to change configuration depending on your needs, just make sure that identical settings are set here and in RTU simulator: Baud rate, data bits, parity, stop bits, flow control
You may need to change configuration depending on your needs, just make sure that identical settings are set here and in RTU simulator: Baud rate, data bits, parity, stop bits, flow control.
[[File:Navigateandenable.png|border|class=tlt-border]]
[[File:Navigateandenable.png|700px|border|class=tlt-border]]
In IP filter options on the bottom of the page, add IP addresses that will be allowed to reach your Modbus gateway (input 0.0.0.0/0 to allow any IP address).
In IP filter options on the bottom of the page, add IP addresses that will be allowed to reach your Modbus gateway (input 0.0.0.0/0 to allow any IP address).
