Template:Networking device leds: Difference between revisions

From Teltonika Networks Wiki
No edit summary
(Added additional information on Signal Strength LEDs and reset button.)
Line 79: Line 79:




The signal strength LEDs can also be used as a <b>time indicator for holding the reset button</b>. When you press and hold the reset button, you have to hold it pressed for 5 seconds (by default) to initiate a factory reset. Depending on a number of signal strength LEDs, time needed to reset router are divided in equal periods, when it passed a new signal strength LED lights up.
The signal strength LEDs can also be used as a <b>time indicator for holding the reset button</b>. When you press and hold the reset button, you have to hold it pressed for 6 seconds (by default) to initiate a User's default configuration reset and 12 seconds (by default) to initiate a factory reset. If the button was held down longer than 20 seconds (by default) no action will be taken.  


In case with <b>{{{name}}}</b>, when all {{{sig_led_num}}} signal strength LEDs are lit up, they represent that 5 seconds have passed since you pressed down on the reset button and you can release it now.
While holding the reset button each lit up signal strength LED indicate that a period of two seconds has passed. In case with <b>{{{name}}}</b>, when all {{{sig_led_num}}} signal strength LEDs are lit up, they represent that {{{sig_led_num}}} * 2 ({{{sig_led_num}}} multiplied by 2) seconds have passed since you pressed down on the reset button.


After releasing the button, all {{{sig_led_num}}} LEDs will start blinking every 1 second. This signifies that the router <b>has begun the factory reset</b>.  
After releasing the button at one of the reset periods, all {{{sig_led_num}}} LEDs will start blinking every 1 second. This signifies that the router <b>has begun the reset</b>.  
  |
  |
}}
}}


[[Category:{{{name}}} Manual]]
[[Category:{{{name}}} Manual]]

Revision as of 13:05, 9 March 2023

This wiki page contains information about {{{name}}} router LEDs and their actions.

Power LED

The power LED is located on the bottom left corner of the front panel, near the power connector:

[[File:{{{file_power_led}}}|{{{size_power_led}}}px]]

It can perform two different actions:

Action Description
LED turned ON Router is powered up
LED turned OFF Router is not power up





[[Category:{{{name}}} Manual]]