158
edits
Changes
Locking Devices to a Mobile Cell (view source)
Revision as of 13:52, 6 April 2023
, 13:52, 6 April 2023no edit summary
'''''Note:''''' Do not use WebUI to change this setting. It has to be done via AT commands.
'''''Note:''''' Do not use WebUI to change this setting. It has to be done via AT commands.
====Finding the serving cell details====
====Finding the serving cell details====
The explanation for the last 3 measurements can be found on our [[Mobile_Signal_Strength_Recommendations|Mobile signal strength recommendations]] page.
The explanation for the last 3 measurements can be found on our [[Mobile_Signal_Strength_Recommendations|Mobile signal strength recommendations]] page.
'''From these outputs, the most fitting cell should be picked, and its EARFCN and PCI value should be noted.'''
'''From these outputs, the most fitting cell should be picked, and its EARFCN and PCI value should be noted.'''
====Setting the device to the airplane mode====
----
To set the device to the airplane mode, run this command:
<pre>gsmctl -A 'AT+CFUN=0'</pre>
'''This process may take up to one minute''', and when it's done, the modem will reply '''OK''' in the terminal.
====Locking to a selected cell====
====Locking to a selected cell====
