Difference between revisions of "RUT301 LEDs"

Latest revision as of 15:33, 27 February 2024

This page contains information the different types of LEDs and their behaviour on a RUT301 device.

The power LED is located on the bottom left corner of the front panel, just under the power connector.

It indicates whether the device is powered on or not.

State	Description
LED turned on	Device is powered on.
LED turned off	Device is not powered on.

There is one LEDs located at the top-left of each Ethernet port (top-right green port is unused).

They provide information on the current states of the Ethernet ports. Each port has one LED:

Below is an explanation on the behaviours of orange LEDs.

State	Description
LED on	A data connection on the port is operational (cable plugged in, end device visible, no data is being transferred).
LED off	No data connection on the port is operational (no cable, bad cable or end device not visible for some other reason (such as damaged network card)).
LED blinking	Connection established and data is being transferred over this port.

@@ Line 11: / Line 11: @@
 | mobile_leds = 0  <!-- number of mobile signal strength type LEDs -->
 | power_leds  = 1  <!-- number of power LEDs -->
-| wan         = 1  <!-- 1 has WAN type LEDs; 0 doesn't have WAN type LEDs -->
+| wan         = 0  <!-- 1 has WAN type LEDs; 0 doesn't have WAN type LEDs -->
 | wifi        = 0  <!-- 1 has WiFi band LEDs; 0 doesn't have WiFi band LEDs -->
 | gigabit     = 0  <!-- 0 if doesn't have gigabit eth ports -->
 }}