| Line 122: |
Line 122: |
| | |} | | |} |
| | | | |
| − | == FCC ==
| + | {{Template: FCC statement Class B}} |
| | | | |
| − | This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
| + | {{Template: ISED Canada statement}} |
| | | | |
| − | # This device may not cause harmful interference.
| + | {{Template: Compliance End Of statement |
| − | # This device must accept any interference received, including interference that may cause undesired operation."
| + | <!------------------------DEVICE-----------------------> |
| | + | | device = TSW030 |
| | + | }} |
| | | | |
| − | This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
| + | =Product Safety and Use= |
| | | | |
| − | * Reorient or relocate the receiving antenna.
| + | ==Operating conditions== |
| − | * Increase the separation between the equipment and receiver.
| |
| − | * Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
| |
| − | * Consult the dealer or an experienced radio/TV technician for help.
| |
| − | | |
| − | FCC Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
| |
| − | | |
| − | === ISED Canada ===
| |
| − | ----
| |
| − | | |
| − | This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science, and Economic Development Canada's license-exempt RSS(s). Operation is subject to the following two conditions:
| |
| − | # This device may not cause interference;
| |
| − | # This device must accept any interference, including interference that may cause undesired operation of the device.
| |
| − | | |
| − | L'émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d'Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
| |
| − | # L'appareil ne doit pas produire de brouillage;
| |
| − | # L'appareil doit accepter tout brouillage radioélectrique subi, mźme si le brouillage est."
| |
| − | | |
| − | Detailed compliance information is available at the following internet address: [https://wiki.teltonika-networks.com/view/Certificates wiki.teltonika-networks.com/view/Certificates].
| |
| − |
| |
| − | | |
| − | [[Image:Instructions_LOGO.png|50px]] This sign means that is necessary to read the User's Manual before you start using the device.
| |
| − | | |
| − | [[Image:WEEE_LOGO.png|50px]] This sign on the package means that all used electronic and electric equipment should not be mixed with general household waste.
| |
| − | | |
| − | [[File:CE_LOGO.png|50px]]Hereby, TELTONIKA NETWORKS declares that this TSW212 is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. The full text of the EU Declaration of Conformity is available at the following internet address: https://wiki.teltonika-networks.com/view/TSW212_CE/RED
| |
| − | | |
| − | [[Image:UKCA_LOGO.png|50px]] Hereby, TELTONIKA NETWORKS declares that the radio equipment type TSW212 is in compliance with Radio Equipment Regulations 2017. The full text of the UK declaration of conformity is available at the following internet address: https://wiki.teltonika-networks.com/view/TSW030_UKCA.
| |
| − | | |
| − | | |
| − | | |
| − | == Operating conditions == | |
| | | | |
| | * Operating temperature: -40° to +75° Celsius | | * Operating temperature: -40° to +75° Celsius |
| Line 171: |
Line 142: |
| | '''Attention:''' operation outside the permissible range can considerably shorten the service life of the device. | | '''Attention:''' operation outside the permissible range can considerably shorten the service life of the device. |
| | | | |
| − | === Faulty and damaged products ===
| + | ==Faulty and damaged products== |
| − | ----
| |
| | | | |
| | * Do not attempt to disassemble the device or its accessories. | | * Do not attempt to disassemble the device or its accessories. |
| Line 178: |
Line 148: |
| | * If your device or its accessories have been submerged in water punctured or subjected to a severe fall, do not use until they have been checked at an authorized service center. | | * If your device or its accessories have been submerged in water punctured or subjected to a severe fall, do not use until they have been checked at an authorized service center. |
| | | | |
| − | === Electrical safety ===
| + | ==Electrical safety== |
| − | ----
| |
| | | | |
| | * Only use approved accessories. | | * Only use approved accessories. |
| Line 185: |
Line 154: |
| | * It is recommended to ground devices with grounding terminals before connecting them to power. Failure to ground appropriately might result in a shock hazard. The cross-sectional area of the protective grounding conductor should be at least 1 mm2. | | * It is recommended to ground devices with grounding terminals before connecting them to power. Failure to ground appropriately might result in a shock hazard. The cross-sectional area of the protective grounding conductor should be at least 1 mm2. |
| | | | |
| − | === Product handling ===
| + | ==Product handling== |
| − | ----
| |
| | | | |
| | * You alone are responsible for how you use your device and any consequences related to its use. | | * You alone are responsible for how you use your device and any consequences related to its use. |
| Line 211: |
Line 179: |
| | * The device may become warm during regular use. | | * The device may become warm during regular use. |
| | | | |
| | + | =Quick Start Guide= |
| | | | |
| − | == Front view== | + | == Front view == |
| | | | |
| | <br> | | <br> |
| − | [[File:TSW030_Front_view_Schematics.jpg|center|600 px|link=Special:FilePath/TSW030_Front_view_Schematics.jpg]] | + | [[File:TSW030_Front_view_Schematics.jpg|center|500 px|link=Special:FilePath/TSW030_Front_view_Schematics.jpg]] |
| | | | |
| | == Back view == | | == Back view == |
| | | | |
| | <br> | | <br> |
| − | [[File:TSW030_Back_view_Schematics.jpg|center|600 px|link=Special:FilePath/TSW030_Back_view_Schematics.jpg]] | + | [[File:TSW030_Back_view_Schematics_v1.jpg|center|500 px|link=Special:FilePath/TSW030_Back_view_Schematics_v1.jpg]] |
| | | | |
| | <br> | | <br> |
| Line 226: |
Line 195: |
| | == Connectors == | | == Connectors == |
| | | | |
| | + | ====Power Socket Pinout==== |
| | + | ---- |
| | + | <br> |
| | + | [[File:tsw010-2-pin-power-socket-pinout.jpg|center|500 px|link=Special:FilePath/tsw010-2-pin-power-socket-pinout.jpg]] |
| | + | |
| | + | ====RJ45 LED Meaning==== |
| | + | ---- |
| | + | <br> |
| | + | [[File:tsw010-rj45-led-meaning.jpg|center|450 px|link=Special:FilePath/tsw010-rj45-led-meaning.jpg]] |
| | + | |
| | + | ==Video Quick Start Guide== |
| | + | |
| | + | Need some help setting up your Teltonika Networks TSW030? Watch our quick start guide video and follow the step-by-step instructions to easily set up your new device for operation. |
| | + | |
| | + | <youtube>vMIS8KE8PLU</youtube> |
| | <br> | | <br> |
| − | <table>
| |
| − | <tr>
| |
| − | <td style="vertical-align: top; margin: 10px; padding-bottom: 25px;">[[File:TSW030-2-pin-power-socket-pinout-table.jpg|left|400 px|link=Special:FilePath/TSW030-2-pin-power-socket-pinout-table.jpg]]</td>
| |
| − | <td style="vertical-align: center; margin: 0px; padding-left: 50px; padding-bottom: 0px;">[[File:TSW030-2-pin-power-socket-pinout.jpg|right|500 px|link=Special:FilePath/TSW030-2-pin-power-socket-pinout.jpg]]</td>
| |
| − | </tr>
| |
| − | <tr>
| |
| − | <td style="vertical-align: top; margin: 10px; padding-bottom: 25px;">[[File:TSW030-rj45-led-meaning-table.jpg|left|400 px|link=Special:FilePath/TSW030-rj45-led-meaning-table.jpg]]</td>
| |
| − | <td style="vertical-align: center; margin: 0px; padding-left: 50px; padding-bottom: 0px;">[[File:TSW030-rj45-led-meaning.jpg|right|500 px|link=Special:FilePath/TSW030-rj45-led-meaning.jpg]]</td>
| |
| − | </tr>
| |
| − | </table>
| |
| | | | |
| | ==Hardware installation == | | ==Hardware installation == |
| Line 251: |
Line 225: |
| | </tr> | | </tr> |
| | </table> | | </table> |
| | + | |
| | + | [[Category: TSW030]] |