Difference between revisions of "Template:Networking tsw0 manual powering options"
From Teltonika Networks Wiki
(One intermediate revision by the same user not shown) | |||
Line 9: | Line 9: | ||
{{Template: Networking_{{lc:{{{series}}}}}_manual_power_socket_pinout}} | {{Template: Networking_{{lc:{{{series}}}}}_manual_power_socket_pinout}} | ||
− | {{# | + | {{#ifeq:{{{poe}}}|1|<b>Note</b> that {{{name}}} PoE ports works properly when switch is powered using PSU, which can supply 44 VDC or higher voltages. If {{{name}}} switch is powered with voltages ranging from 7 VDC to 43 VDC, it will work as standard switch, without PoE capabilities.|}} |
− | |||
− | |||
− | |||
− | <b>Note</b> that {{{name}}} PoE ports works properly when switch is powered using PSU, which can supply 44 VDC or higher voltages. If {{{name}}} switch is powered with voltages ranging from 7 VDC to 43 VDC, it will work as standard switch, without PoE capabilities. | ||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | }} | ||
{{#ifeq:{{{passive_poe}}}|1| | {{#ifeq:{{{passive_poe}}}|1| |
Revision as of 11:36, 8 May 2024
This chapter contains information on powering options supported by {{{name}}} switch.
The switch has a 2 pin power socket and can be powered by a 7-30 VDC power supply unit (PSU). Refer to the image below for the power socket's pinout information:
Power socket
{{Template: Networking_{{{series}}}_manual_power_socket_pinout}}
[[Category:{{{name}}} Manual]]