105
edits
Changes
Template:Networking manual Modbus serial RutOS (view source)
Revision as of 10:46, 21 August 2024
, 21 August→Configuring Modbus serial slave device
When you are done with that, open the app and apply the following configuration.
When you are done with that, open the app and apply the following configuration.
<table class="nd-othertables_2">
<tr>
<th width=330; style="border-bottom: 1px solid white;></th>
<th width=800; style="border-bottom: 1px solid white"; rowspan=2>[[File:Networking_rut955_configuration_modbus_serial_1_v1.png|border|class=tlt-border|right]]</th>
</tr>
<tr>
<td style="border-bottom: 4px solid white>
# Select '''Protocol''' (MODBUS RS-232).
# Select '''Protocol''' (MODBUS RS-232).
# Click '''Setup the communication Serial or TCP/IP port'''.
# Click '''Setup the communication Serial or TCP/IP port'''.
</td>
</tr>
</table>
----
----
<table class="nd-othertables_2">
<tr>
<th width=330; style="border-bottom: 1px solid white;></th>
<th width=800; style="border-bottom: 1px solid white"; rowspan=2>[[File:Networking_rut955_configuration_modbus_serial_2_v1.png|border|class=tlt-border|center]]</th>
</tr>
<tr>
<td style="border-bottom: 4px solid white>
# Select the '''Port''' which you connected RS232 cable to (to find which port you are using go to Windows search bar and write '''Device Manager''' then select '''Ports''' and see which one you are using).
# Select the '''Port''' which you connected RS232 cable to (to find which port you are using go to Windows search bar and write '''Device Manager''' then select '''Ports''' and see which one you are using).
# Select '''Parity''' (Even).
# Select '''Parity''' (Even).
# Click '''OK'''.
# Click '''OK'''.
</td>
</tr>
</table>
==Configuring Modbus serial master==
==Configuring Modbus serial master==