Line 2,457: |
Line 2,457: |
| To create one enter its name and click the <b>Add</b> button. | | To create one enter its name and click the <b>Add</b> button. |
| To configure it click the <b>Edit</b> [[File:Networking_rutx_manual_edit_button_v1.png]] button. | | To configure it click the <b>Edit</b> [[File:Networking_rutx_manual_edit_button_v1.png]] button. |
− | [[File:Networking_rutx_vpn_tinc_instance_hosts.png|border|class=tlt-border]] | + | [[File:Networking_rutx_vpn_tinc_instance_hosts_v1.png|border|class=tlt-border]] |
| | | |
| | | |
Line 2,465: |
Line 2,465: |
| In the General section of Hosts instance you can configure basic information about the host. | | In the General section of Hosts instance you can configure basic information about the host. |
| | | |
− | [[File:Networking_rutos_vpn_tinc_instance_hosts_general.png|border|class=tlt-border]] | + | [[File:Networking_rutos_vpn_tinc_instance_hosts_general_v1.png|border|class=tlt-border]] |
| | | |
| <table class="nd-mantable"> | | <table class="nd-mantable"> |
Line 2,475: |
Line 2,475: |
| <tr> | | <tr> |
| <td>Enable</td> | | <td>Enable</td> |
− | <td>off | on; default: <b>off</b></td> | + | <td>off {{!}} on; default: <b>off</b></td> |
| <td>Turn this tinc host on/off.</td> | | <td>Turn this tinc host on/off.</td> |
| </tr> | | </tr> |
Line 2,485: |
Line 2,485: |
| <tr> | | <tr> |
| <td>Address</td> | | <td>Address</td> |
− | <td>ip; default: <b>none</b></td> | + | <td>IP addresses with an optional port number; default: <b>none</b></td> |
− | <td>It must resolve to the external IP address where the host can be reached, not the one that is internal to the VPN.</td> | + | <td>Remote host's IP address or domain name, optionally followed by a port number (e.g., example.com:8080). If no port is specified, the default port (655) will be used.</td> |
| </tr> | | </tr> |
| <tr> | | <tr> |
| <td>Subnet</td> | | <td>Subnet</td> |
− | <td>ip; default: <b>none</b></td> | + | <td>IPv4, IPv6 or MAC addresses; default: <b>none</b></td> |
− | <td>The subnet which this tinc daemon will serve. Multiple subnet lines can be specified for each Daemon.</td> | + | <td>Specify the host-side subnets you need to access. You can add multiple subnet entries for each daemon.</td> |
| </tr> | | </tr> |
| <tr> | | <tr> |
Line 2,499: |
Line 2,499: |
| </tr> | | </tr> |
| </table> | | </table> |
| + | |
| {{#ifeq: {{{tailscale}}} | 1 | | | {{#ifeq: {{{tailscale}}} | 1 | |
− |
| |
| ==Tailscale== | | ==Tailscale== |
| | | |