Difference between revisions of "Template:Webui services rs232 rs232 configuration modem"
From Teltonika Networks Wiki
(Created page with "In '''Modem''' serial type, the device imitates a dial-up modem. Connections to TCP/IP networks can be established using AT commands. The connection can be initiated by the de...") |
|||
Line 1: | Line 1: | ||
− | In | + | In '''Modem''' serial type, the device imitates a dial-up modem. Connections to TCP/IP networks can be established using AT commands. The connection can be initiated by the device connected via serial interface with an ATD command: '''ATD <host>:<port>'''. If Direct connect settings are specified, the connection to the server is always active. Data mode can be entered by issuing the ATD command. Incoming connections are indicated by sending a RING to the serial interface. |
The figure below is an example of available configuration fields for the Modem serial type and the table below provides information on these fields: | The figure below is an example of available configuration fields for the Modem serial type and the table below provides information on these fields: |
Revision as of 11:15, 18 October 2018
In Modem serial type, the device imitates a dial-up modem. Connections to TCP/IP networks can be established using AT commands. The connection can be initiated by the device connected via serial interface with an ATD command: ATD <host>:<port>. If Direct connect settings are specified, the connection to the server is always active. Data mode can be entered by issuing the ATD command. Incoming connections are indicated by sending a RING to the serial interface.
The figure below is an example of available configuration fields for the Modem serial type and the table below provides information on these fields: