Line 26: |
Line 26: |
| [[File:Netoworking rut configuration example gre via cli 02.png|border]] | | [[File:Netoworking rut configuration example gre via cli 02.png|border]] |
| <li>Configuring GRE Tunnel</li> | | <li>Configuring GRE Tunnel</li> |
− | <div>GRE Tunnel configuration is found at '''/etc/config/gre_tunnel'''. Use the '''vi''' command to access and edit the following configuration.</div> | + | <div>GRE Tunnel configuration should be written in the file '''/etc/config/network'''. Use the '''vi''' command to access and edit according the following configuration.</div> |
| </ul> | | </ul> |
| | | |
− | Access to the RUTxxx via CLI or SHH. | + | Access to the RUTxxx via CLI or SHH. '''Note:''' The instructions to remote access are in this link https://wiki.teltonika-networks.com/view/Command_line_interfaces |
− | <li>'''Note:''' The instructions to access are in this link https://wiki.teltonika-networks.com/view/Command_line_interfaces</li>
| |
| | | |
| + | Since you access to the SSH or CLI, write '''vi /etc/config/network''', then click on the '''i''' letter and navigate to the end of the file. |
| | | |
| | | |
− | [[File:Networking_rutxxx_configuration_example_gre_instance_v1.png|border|class=tlt-border]]
| |
− |
| |
− | Then apply the configuration presented below.
| |
− |
| |
− | [[File:Networking_rutxxx_configuration_example_rut_settings_v1.png|border|class=tlt-border]]
| |
− |
| |
− | #'''Enable''' instance.
| |
− | #Select '''Tunnel source''' (select your WAN interface).
| |
− | #Enter '''Remote endpoint IP address''' (Cisco WAN IP).
| |
− | #Set '''MTU''' to '''1440'''.
| |
− | #Write '''Local GRE interface IP address''' (create GRE tunnel IP address or just use the same as in the example).
| |
− | #Write '''Local GRE interface netmask''' (create GRE tunnel netmask or just use the same as in the example)
| |
− | #Leave everything else as default and click '''Save'''.
| |
− |
| |
− | ==Cisco configuration==
| |
− |
| |
− | Connect to router's '''WebUI''', go to '''VPN > GRE Tunnel''' and apply the following configuration.
| |
− |
| |
− | [[File:Networking_rutxxx_configuration_example_cisco_settings_v1.png|border|class=tlt-border]]
| |
− |
| |
− | #Write '''GRE Tunnel Description''' (anything you want).
| |
− | #Select '''Source''' (select your WAN interface).
| |
− | #Enter '''Destination''' (RUT WAN IP).
| |
− | #Write '''IP Address Of GRE Tunnel''' (create GRE tunnel IP address or just use the same as in the example).
| |
− | #Write '''Subnet Mask''' (create GRE tunnel netmask or just use the same as in the example).
| |
− | #Set '''MTU''' to '''1440'''.
| |
− | #Leave everything else as default and save settings.
| |
| | | |
| ==Testing configuration== | | ==Testing configuration== |