RUTXR1 Powering Options: Difference between revisions

From Teltonika Networks Wiki
No edit summary
m (Protected "RUTXR1 Powering Options" ([Edit=Allow only administrators] (indefinite) [Move=Allow only administrators] (indefinite)))
(4 intermediate revisions by 2 users not shown)
Line 2: Line 2:
| name              = RUTXR1
| name              = RUTXR1
| series            = RUTX
| series            = RUTX
| file_lan1        = Networking_rutxr1_manual_powering_options_lan1_v1.png
| size_lan1        = 800
| file_power_socket = Networking_rutx_manual_power_socket_pinout_v1.png
}}
}}

Revision as of 18:14, 21 April 2020

Main Page > RUTX Routers > RUTXR1 > RUTXR1 Manual > RUTXR1 Powering Options

This chapter contains information on powering options supported by RUTXR1 routers.

Power socket

The router has a 4 pin power socket and can be powered by a 9-50 VDC power supply unit (PSU). Refer to the image below for the power socket's pinout information:

Power socket pinout
No. Description Wire color
1 Power Red
2 Ground Black
3 Input Green
4 Output White

If you decide not to use the standard 9 VDC wall adapter and want to power the device from a higher voltage (15-50 VDC), please make sure that you choose a power supply of high quality. Some power supplies can produce voltage peaks significantly higher than the declared output voltage, especially during connection and disconnection.

While the device is designed to accept input voltage of up to 50 VDC peaks, high voltage power supplies can harm the device. If you want to use high voltage power supplies it is recommended to also use additional safety equipment to suppress voltage peaks from the power supply.

Suggestion: If you're using a different power supply than the one included in the standard packaging, make sure it meets the same power (W) specifications as the original. Otherwise, some features of the device might not work properly. Please refer to the device's portfolio page to verify the power supply specifications: Power Consumption

Simultaneous powering

The device can be powered from both its power sockets simultaneously. The power socket with "M" marking (standing for "Main") has higher priority meaning that the device will draw power from the power socket as long as it is available.

When the device is switching from one power source to another it loses power for a fraction of a second and may reboot. The device will function correctly after the reboot.

Ground loops

Do not connect the power supply negative terminal of our device to the chassis or earth exclusively.

This connection could cause ground loops. For example, if the antenna shield and power supply negative terminal are connected to the chassis or earth, it forms a ground loop, therefore unwanted current could flow through a device PCB ground and may cause damage.