Difference between revisions of "Template:Networking rut2xx manual modbus modbus tcp set parameters table"
From Teltonika Networks Wiki
(One intermediate revision by the same user not shown) | |||
Line 2: | Line 2: | ||
<tr> | <tr> | ||
<th width="350">value to set</th> | <th width="350">value to set</th> | ||
− | <th width="180">register | + | <th width="180">register address</th> |
<th width="150">register value</th> | <th width="150">register value</th> | ||
<th width="466">description</th> | <th width="466">description</th> | ||
+ | </tr> | ||
+ | <tr> | ||
+ | <td>Hostname</td> | ||
+ | <td>7</td> | ||
+ | <td>Hostname</td> | ||
+ | <td>Changes hostname</td> | ||
+ | </tr> | ||
+ | <tr> | ||
+ | <td>Device name</td> | ||
+ | <td>71</td> | ||
+ | <td>Device name</td> | ||
+ | <td>Changes device name</td> | ||
</tr> | </tr> | ||
<tr> | <tr> | ||
Line 17: | Line 29: | ||
<td>1 | 0</td> | <td>1 | 0</td> | ||
<td>Turns mobile data connection ON or OFF</td> | <td>Turns mobile data connection ON or OFF</td> | ||
+ | </tr> | ||
+ | <tr> | ||
+ | <td>Reboot</td> | ||
+ | <td>206</td> | ||
+ | <td>1</td> | ||
+ | <td>Reboots the router</td> | ||
</tr> | </tr> | ||
<tr> | <tr> | ||
Line 25: | Line 43: | ||
</tr> | </tr> | ||
<tr> | <tr> | ||
− | + | <td>Switch PIN4 state (ON/OFF<span class="asterisk">*</span>)</td> | |
− | + | <td>325</td> | |
− | + | <td>1 | 0</td> | |
− | <td> | + | <td>Turns PIN4 state ON or OFF</td> |
</tr> | </tr> | ||
</table> | </table> |
Revision as of 12:04, 15 July 2020
value to set | register address | register value | description |
---|---|---|---|
Hostname | 7 | Hostname | Changes hostname |
Device name | 71 | Device name | Changes device name |
Switch WiFi (ON/OFF*) | 203 | 1 | 0 | Turns WiFi ON or OFF |
Switch mobile data connection (ON/OFF*) | 204 | 1 | 0 | Turns mobile data connection ON or OFF |
Reboot | 206 | 1 | Reboots the router |
Change APN | 207 | APN code | Changes APN. The number of input registers may vary depending on the length of the APN, but the very first byte of the set APN command has to be specified as 1 |
Switch PIN4 state (ON/OFF*) | 325 | 1 | 0 | Turns PIN4 state ON or OFF |