| Line 1: |
Line 1: |
| − | __TOC__
| + | {{Template: Gsmctl_commands |
| − | ==Introduction== | + | <!------------------------DEVICE-----------------------> |
| − | | + | | series = RUT9XX |
| − | '''''gsmctl''''' is an SSH command used to communicate with a RUTxxx router's modem. In other words, ''gsmctl'' relays '''AT''' commands (a set of instructions used to control a modem) to the router's modem; thus, providing the user with a way to control and obtain information from the modem via SSH. This can be used to either obtain certain modem related variables (signal strength, operator, connection state, etc.) or to execute certain actions (sending SMS messages, changing the frequency band, etc.).
| + | | fw_version = R_00.06.08.3 and below |
| − | | + | | name = RUT |
| − | This article provides a complete overview on ''gsmctl'' commands available in RUTxxx routers.
| + | }} |
| − | | |
| − | ==Prerequisites==
| |
| − | | |
| − | ''gsmctl'' commands can be used on all RUTxxx routers via any type of command line interface (CLI) supported by the router. So all you need is:
| |
| − | * a RUTxxx router
| |
| − | * knowledge on how to login via a '''[[Command line interfaces|command line interface]]'''
| |
| − | | |
| − | ==gsmctl options==
| |
| − | | |
| − | ===Get IP address of logical interface===
| |
| − | | |
| − | ===Get number of bytes sent===
| |
| − | | |
| − | ===Get number of bytes received===
| |
| − | | |
| − | ===Get 3G connection state===
| |