Difference between revisions of "TRB143 Device Recovery Options"
Gytispieze (talk | contribs) (Created page with "{{Template: networking_device_manual_device_recovery | name = TRB143 | series = TRB14x | file_reset_button = Networking_trb140_manual_device_recovery_b...") |
Gytispieze (talk | contribs) m (Gytispieze moved page Draft:TRB143 Device Recovery Options to TRB143 Device Recovery Options without leaving a redirect) |
(No difference)
|
Revision as of 10:36, 19 May 2022
Main Page > TRB Gateways > TRB143 > TRB143 Manual > TRB143 Device Recovery OptionsSummary
This chapter is an overview on various recovery options for a TRB143 device.
Default login information
Using recovery methods resets the device's configuration to its default state. Therefore, you will need to use the default authentication info in order to login to the device. The default login information for TRB143 is provided below:
- Default Address (LAN IP): 192.168.2.1
- Default Username: admin
- Default Password: admin01 or random generated password*
Devices with random password
* Certain devices or batches of a device may have a generated password out of the box, instead of admin01. For TRB143 devices, batch from when unique passwords are used is 3
You can find the batch of your device on the Product Labels sticker.
Factory reset
A factory reset returns the device back to its default factory settings, i.e., it deletes all custom configurations. Below you will find various methods of performing a factory reset on TRB143.
Additional note: SIM PIN on the main SIM card is the only user parameter that is kept after a factory reset.
Reset Button
The reset button is located on the {{{panel}}} of the device:
The reset button has two functions:
- Reboot the device. If the reset button is pressed for up to 4 seconds, the device will reboot. Start of the reboot will be indicated by the flashing of all 5 signal strength LEDs together with the green connection status LED.
- Factory reset. If the reset button is pressed for at least 12 seconds (by default), the device will perform a factory reset and reboot.
NOTE: the default button hold time value (min time 12 seconds, max time 20 seconds) can be changed in the gateway WebUI, from the System → Administration → General page.
WebUI
You can also perform a factory reset from the gateway's WebUI. To do so, login to the gateway and go to the Backup section found under the System tab (System → Maintenance → Backup → Reset settings). In the very bottom of the page there's a Reset button that performs a chosen type of reset.
Notice: A Factory defaults reset will remove all logs, SIM PIN's and RMS data that the device might have had.
Command line
You can perform a factory reset via command line by executing the firstboot command. After this you will be asked to confirm the reset. If you're sure, type the letter y and press "Enter" or type the letter n if you wish to cancel the reset.
If you agreed to perform a factory reset, next type in reboot and press "Enter". The gateway will be reset to it's factory settings and rebooted. The entire sequence of events should look like this:
For firmwares TRB14X_R_00.02.04.1 and newer:
root@Teltonika-TRB143:~# firstboot This will erase all settings and remove any installed packages. Are you sure? [N/y] y /dev/mtdblock5 is mounted as /overlay, only erasing files root@Teltonika-TRB143:~# reboot
For firmwares TRB14X_R_00.02.03.2 and lower:
root@TRB143:~# factory_restore Are you sure (y/n)? y
You can find more information on the command line interface (CLI) here.
RMA
If conventional recovery methods do not help, you may need to send the device to warranty for repair. The warranty process is described here.