TSF010 LEDs: Difference between revisions
Created page with "{{Template:Networking device leds | name = TSF010 | series = TSF | file_power_led = Network_tsf_manual_tsf010_pwr_led.png | size_power_led = 400 | eth_leds = 1 | file_eth_led..." |
m Vainius.l moved page Draft:TSF010 LEDs to TSF010 LEDs without leaving a redirect |
||
| (One intermediate revision by the same user not shown) | |||
| Line 5: | Line 5: | ||
| size_power_led = 400 | | size_power_led = 400 | ||
| eth_leds = 1 | | eth_leds = 1 | ||
}} | }} | ||
Latest revision as of 08:21, 8 May 2024
Main Page > TSF Switches > TSF010 > TSF010 Manual > TSF010 LEDsThis wiki page contains information about TSF010 router LEDs and their actions.
Power LED
The power LED is located on the bottom left corner of the front panel, near the power connector:
It can perform two different actions:
| Action | Description |
|---|---|
| LED turned ON | Switch is powered up |
| LED turned OFF | Switch is not power up |
Ethernet port
There is one LEDs located at the top-left of each Ethernet port (top-right green port is unused).
They provide information on the current states of the Ethernet ports. Each port has one LED:
- Orange - 10/100 Mbps connection
Below is an explanation on the behaviours of orange LEDs.
| State | Description |
|---|---|
| LED on | A data connection on the port is operational (cable plugged in, end device visible, no data is being transferred). |
| LED off | No data connection on the port is operational (no cable, bad cable or end device not visible for some other reason (such as damaged network card)). |
| LED blinking | Connection established and data is being transferred over this port. |