Template:Networking tsw1xx manual powering options: Difference between revisions

Revision as of 10:30, 7 February 2023

This chapter contains information on powering options supported by {{{name}}} switch.

The switch has a pin power socket and can be powered by a VDC power supply unit (PSU). Refer to the image below for the power socket's pinout information:

Power socket

{{Template: Networking_{{{series}}}_manual_power_socket_pinout | name = {{{name}}} }}

{{#switch:{{{name}}} | TSW100|TSW101= ==Disclaimer: {{{name}}} and Passive PoE devices==

There are a couple of options to stay safe when using {{{name}}} Active PoE with devices that only support Passive PoE:

Connect {{{name}}} and Passive PoE device only via non-PoE Ethernet ports (for example, do not use {{{name}}} PoE ports with LAN1 ports on Teltonika devices).
If there is a need to use LAN1 port on the end device, make sure that {{{name}}} and the end device are powered from different voltage sources (for example, power both devices from different PSUs, or different batteries).

If {{{name}}} and a Passive PoE device are connected with common ground, do not use LAN1 port, other ports can be used (refer to image below):

[[Category:{{{name}}} Manual]]

@@ Line 34: / Line 34: @@
 [[File:Passive - Active PoE common ground connection.jpg|400px|border|class=tlt-border]]
-}}
+{{#ifeq:{{{passive_poe}}}|1|
+{{Template: networking_device_manual_powering_options_passive_poe
+  | series    = {{{series}}}
+  | file_lan1 = {{{file_lan1}}}
+  | size_lan1 = {{{size_lan1}}}
+}}|}}
 [[Category:{{{name}}} Manual]]