Mobile Parameters to HTTP Server: Difference between revisions
No edit summary |
No edit summary |
||
| Line 22: | Line 22: | ||
* 1 PC | * 1 PC | ||
* HTTP Server (Hercules) | * HTTP Server (Hercules) | ||
==Preparation== | |||
* Prepare RUTX14, power up the device, insert the sim card, check that mobile interface is active and working. SIM1, PWR and signal strength indicators should light up. | |||
'''Network -> Interfaces''' should look similar to this: | |||
[[File:Screenshot 1.png|center]] | |||
Revision as of 10:44, 6 April 2023
Introduction
Mobile parameters are needed to measure signal features that can be acquired using gsmctl commands. However, there is no available command to check/display all of the desired details.
With that said, a custom script is needed to show them using one command. This article provides step-by-step instructions on how to write the script, programs that are required, and how to run it.
- First you want to make sure that you have ADVANCED mode enabled. This will allow you to choose from a larger variety of settings.
Prerequisites
For this particular configuration you will need:
- A Gateway or a Router with GSM (RUTX14 is being used in the example)
- 1 SIM card
- 1 PC
- HTTP Server (Hercules)
Preparation
- Prepare RUTX14, power up the device, insert the sim card, check that mobile interface is active and working. SIM1, PWR and signal strength indicators should light up.
Network -> Interfaces should look similar to this:
