Changes

You again will be redirected to following window, where you will need to enter WPA passphrase or other security password depending on AP that you are connecting to, name yours network (it will be name of your wireless WAN interface) and assign firewall rule.

You again will be redirected to following window, where you will need to enter WPA passphrase or other security password depending on AP that you are connecting to, name yours network (it will be name of your wireless WAN interface) and assign firewall rule.

[[File:Networking_rutos_manual_wireless_scan_button_results_join_network_v1.png|border|class=tlt-border]]  

[[File:Networking_rutos_manual_wireless_scan_button_results_join_network_v2.png|border|class=tlt-border]]  

Next window that opens will be '''Device Configuration'''. Values there, mostly, should be left unchanged to avoid connection problems, because they are dictated by Access Point. Other than that, only difference from Access Point settings are in ''Interface Configuration → General Setup'' section, where '''Mode''' is set to '''Client''', and '''Network''' attached to this wireless interface is '''WAN''' instead of LAN

Next window that opens will be '''Device Configuration'''. Values there, mostly, should be left unchanged to avoid connection problems, because they are dictated by Access Point. Other than that, only difference from Access Point settings are in ''Interface Configuration → General Setup'' section, where '''Mode''' is set to '''Client''', and '''Network''' attached to this wireless interface is '''WAN''' instead of LAN

[[File:Networking_rutos_manual_wireless_scan_button_results_join_network_general_setup.png|border|class=tlt-border]]

[[File:Networking_rutos_manual_wireless_scan_button_results_join_network_general_setup_v2.png|border|class=tlt-border]]

Click '''Save & Apply''' and if you configured correctly, you will have Wireless Client working.

Click '''Save & Apply''' and if you configured correctly, you will have Wireless Client working.