Template:Networking tswos manual diagnostics: Difference between revisions
(Created page with "{{Template: Networking_rutos_manual_fw_disclosure | fw_version ={{Template: Networking_rutos_manual_latest_fw | series = {{{series}}} | name = {{{name}}} }} }} __TOC__ ==...") |
No edit summary |
||
| Line 46: | Line 46: | ||
</table> | </table> | ||
==Cable Diagnostic== | |||
---- | ---- | ||
This <b>Cable Diagnostcis</b> service is dedicated to provide information about cable status and length. Full cable diagnostic is performed only when the cable is connected to the switch device. When the cable is fully connected only the cable length measurements will be provided. Note: the provided cable information may not be fully accurate and margin of error could be expected. | This <b>Cable Diagnostcis</b> service is dedicated to provide information about cable status and length. Full cable diagnostic is performed only when the cable is connected to the switch device. When the cable is fully connected only the cable length measurements will be provided. Note: the provided cable information may not be fully accurate and margin of error could be expected. | ||
Revision as of 13:52, 12 October 2023
Template:Networking rutos manual fw disclosure
Network Diagnostics
Diagnostics
This Diagnostcis section is used to execute simple network diagnostic tests, including ping, traceroute and nslookup.
| Field | Value | Description |
|---|---|---|
| Method | Ping | Traceroute | Nslookup; default: Ping | Specifies the diagnostics method.
|
| Protocol | IPv4 | IPv6; default: IPv4 | Selects the IP (Internet Protocol) version. |
| Address | ip; default: none | IP address or hostname to perform the diagnostic test on. |
| Perform | -(interactive) button | Performs the diagnostic test. |
Cable Diagnostic
This Cable Diagnostcis service is dedicated to provide information about cable status and length. Full cable diagnostic is performed only when the cable is connected to the switch device. When the cable is fully connected only the cable length measurements will be provided. Note: the provided cable information may not be fully accurate and margin of error could be expected.
To run cable diagnostic, select ports and press 'Run Diagnostic' button:
[[Category:{{{name}}} Services section]]