Changes

*Three RUTOS devices with different LAN networks

*Three RUTOS devices with different LAN networks

*One RUTOS device will need to have a '''Public IP''' address

*One RUTOS device will need to have a '''Public IP''' address

*An end device with the ability to install, set up WireGuard client, and configure RUTOS devices

*An end device with the ability to install, set up WireGuard client, and configure RUTOS devices<br>

*'''WebUI''' switched into '''Advanced''' mode

'''Note:''' remember to switch the '''WebUI''' into '''Advanced''' mode.

==WireGuard instance creation==

==WireGuard instance creation==

*Set an IP address. For the '''server''' set '''10.0.0.1/24'''. For the '''clients''' set the IP to '''10.0.0.2/24 and higher'''. For example, client #1 – IP 10.0.0.2/24, client #2 – IP 10.0.0.3/24, and so on

*Set an IP address. For the '''server''' set '''10.0.0.1/24'''. For the '''clients''' set the IP to '''10.0.0.2/24 and higher'''. For example, client #1 – IP 10.0.0.2/24, client #2 – IP 10.0.0.3/24, and so on

Below is an example of the server’s WireGuard interface:<br>

Below is an example of the server’s WireGuard interface:<br>

[[File:WG server interface.png|border|class=tlt-border]]

[[File:Wireguard server interface config example v1.png|border|class=tlt-border]]

==Peers Configuration==

==Peers Configuration==

===Client 3 configuration===

===Client 3 configuration===

Firstly, ensure that you have downloaded and installed WireGuard client (https://www.wireguard.com/install/) for your PC. To create client #3 to server/peer configuration, follow these steps:

Firstly, ensure that you have downloaded and installed WireGuard client ([https://www.wireguard.com/install/ wireguard.com/install]) for your PC. To create client #3 to server/peer configuration, follow these steps:

*Launch the WireGuard software

*Launch the WireGuard software

*At the bottom of the left corner select '''Add Tunnel → Add empty tunnel…'''

*At the bottom of the left corner select '''Add Tunnel → Add empty tunnel…'''<br>

*In the configuration window add these settings:

*In the configuration window add these settings:

  Address = 10.0.0.4/32

  Address = 10.0.0.4/32

*Enable '''Route allowed IPs'''

*Enable '''Route allowed IPs'''

*Press [[File:Save apply button.png]]

*Press [[File:Save apply button.png]]

The final results could look like this:<br>

The final results of all the server's peers could look like this:<br>

[[File:Wireguard server to client all peers v2.png|border|class=tlt-border]]

[[File:Wireguard server to client all peers v2.png|border|class=tlt-border]]