Template:Networking ntp manual leds: Difference between revisions

Revision as of 14:23, 27 January 2025

This page contains information the different types of LEDs and their behaviour on a {{{name}}} device.

The power LED is located on the bottom left corner of the front panel, just under the power connector.

[[File:Networking_{{{name}}}_manual_leds_power_led.png|500px]]

It indicates whether the device is powered on or not.

State	Description
LED turned on	Device is powered on.
LED turned off	Device is not powered on.

@@ Line 141: / Line 141: @@
 The IO LEDs can also be used as a <b>time indicator for holding the reset button</b>. When you press and hold the reset button, if there is a User's default configuration configured on the device, you have to hold it pressed for 6 seconds (by default) to initiate a <b>User's default configuration reset</b> and 12 seconds (by default) to initiate a <b>Factory reset</b>. Otherwise, it is only necessary to hold the reset button for 6 seconds to trigger a <b>Factory reset</b>. If the button was held down longer than 20 seconds (by default) no action will be taken.
-While holding the reset button each lit up IO LED indicate that a period of two seconds has passed. In case with <b>{{{name}}}</b>, when all 3 IO indication LEDs are lit up, they represent that 3 * 2 (LED number multiplied by 2) seconds have passed since you pressed down on the reset button.
+While holding the reset button each lit up IO LED indicate that a period of two seconds has passed. In case with <b>{{{name}}}</b>, when all 3 IO indication LEDs are lit up, they represent that 6 (LED number multiplied by 2) seconds have passed since you pressed down on the reset button.
 After releasing the button at one of the reset periods, all 3 LEDs will start blinking every 1 second. This signifies that the router <b>has begun the reset</b>.|}}