Template:Networking rutos manual leds: Difference between revisions
No edit summary |
No edit summary |
||
| Line 553: | Line 553: | ||
| #default = The <b>mobile signal strength indication LEDs</b> are located near the SIM card slot.}}}} | | #default = The <b>mobile signal strength indication LEDs</b> are located near the SIM card slot.}}}} | ||
{{#switch: {{{name}}} | RUTM30 | RUTM31 = | #default = | |||
[[File:Networking_{{lc:{{{name}}}}}_manual_leds_mobile_signal_strength_leds.png|500px]] | [[File:Networking_{{lc:{{{name}}}}}_manual_leds_mobile_signal_strength_leds.png|500px]] | ||
| Line 610: | Line 610: | ||
</tr> | </tr> | ||
</table> | </table> | ||
}} | }}}} | ||
The Mobile signal strength LEDs can also be used as a <b>time indicator for holding the reset button</b>. When you press and hold the reset button, if there is a User's default configuration configured on the device, you have to hold it pressed for 6 seconds (by default) to initiate a <b>User's default configuration reset</b> and 12 seconds (by default) to initiate a <b>Factory reset</b>. Otherwise, it is only necessary to hold the reset button for 6 seconds to trigger a <b>Factory reset</b>. If the button was held down longer than 20 seconds (by default) no action will be taken. | The Mobile signal strength LEDs can also be used as a <b>time indicator for holding the reset button</b>. When you press and hold the reset button, if there is a User's default configuration configured on the device, you have to hold it pressed for 6 seconds (by default) to initiate a <b>User's default configuration reset</b> and 12 seconds (by default) to initiate a <b>Factory reset</b>. Otherwise, it is only necessary to hold the reset button for 6 seconds to trigger a <b>Factory reset</b>. If the button was held down longer than 20 seconds (by default) no action will be taken. | ||
Revision as of 07:41, 26 May 2025
This page contains information the different types of LEDs and their behaviour on a {{{name}}} device.
Power LED
The power LED is located on the bottom left corner of the front panel, just under the power connector.
[[File:Networking_{{{name}}}_manual_leds_power_led.png|500px]]
It indicates whether the device is powered on or not.
| State | Description |
|---|---|
| M LED turned on | Device is powered over the Main power connector. |
| M LED turned off | Device is not powered over the Main power connector. |
| R LED turned on | Device is powered over the Reserve power connector. |
| R LED turned off | Device is not powered over the Reserve power connector. |
[[Category:{{{name}}} Manual]]