TRB140 Static Routes: Difference between revisions

Revision as of 17:25, 21 November 2019

Summary

Routing is the process of selecting a path for traffic in a network or between or across multiple networks. This chapter is an overview of the Routing section for TRB140 routers.

Static IPV4 Routes

field name	value	description
Interface	lan \| mobile \| eth0	The zone where the target network resides
Target*	ip; Default: 0.0.0.0	The address of the destination network
IPv4-Netmask*	ip; Default: 0.0.0.0	A Mask that is applied to the Target to determine to what actual IP addresses the routing rule applies
IPv4-Gateway	ip; Default: " "	Defines where the router should send all the traffic that applies to the rule
Metric	integer; Default: 0	The Metric value is used as a sorting measure. If a packet about to be routed fits two rules, the one with the higher metric is applied
MTU
Route Type

@@ Line 1: / Line 1: @@
+== Summary ==
+'''Routing''' is the process of selecting a path for traffic in a network or between or across multiple networks. This chapter is an overview of the Routing section for TRB140 routers.
+== Static IPV4 Routes ==
-'''Routing''' is the process of selecting a path for traffic in a network or between or across multiple networks. This chapter is an overview of the Routing section for TRB140 routers.
+[[File:Networking rutx manual routing static routes v1.png|center|thumb|1154x1154px]]
-<br />
+<table class="nd-mantable"><tr><th>field name</th><th>value</th><th>description</th></tr><tr><td>Interface</td><td>lan | mobile | eth0  </td><td>The zone where the target network resides</td></tr><tr><td>Tar'''get*'''</td><td>ip; Default: '''0.0.0.0'''</td><td>The address of the destination network</td></tr><tr><td>IPv4-Netmask'''*'''</td><td>ip; Default: '''0.0.0.0'''</td><td>A Mask that is applied to the Target to determine to what actual IP addresses the routing rule applies</td></tr><tr><td>IPv4-Gateway</td><td>ip; Default: " "</td><td>Defines where the router should send all the traffic that applies to the rule</td></tr><tr><td>Metric</td><td>integer; Default: '''0'''</td><td>The '''Metric''' value is used as a sorting measure. If a packet about to be routed fits two rules, the one with the higher metric is applied</td></tr><tr><td>MTU</td><td></td><td></td></tr><tr><td>Route Type</td><td></td><td></td></tr></table><br />
-[[File:Networking TRB manual routing static routes.png|alt=Static routes|border|thumb|1104x1104px]]