Setting up WAN as LAN: Difference between revisions
(Changed most of instruction) |
m (Protected "Setting up WAN as LAN" ([Edit=Allow only administrators] (indefinite) [Move=Allow only administrators] (indefinite))) |
(No difference)
| |
Revision as of 10:06, 14 February 2022
Main Page > General Information > Configuration Examples > LAN > Setting up WAN as LANIntroduction
This article provides a guide on how to configure WAN port as LAN. These configurations are specifically made for RUTOS devices.
Configuring WAN as LAN
- First you want to make sure that you have ADVANCED mode enabled. This will allow you to choose from a larger variety of settings.
- After that navigate to Network > Interfaces
- Disable WAN and WAN6 interfaces
- Click Save & Apply
- Next we will edit our LAN interface and navigate to Physical settings where we will add Interface item from the dropdown menu.
- In interface tab, add both "eth0" and "eth1" interfaces
- It should result in something like this.
- Once you're done with configurations above just save any changes you made.
- Wait a minute or two for the changes to take effect. If there is no effect, reboot the device.
At this point, WAN port should work as LAN. Go ahead and try to swap from your to current port to WAN, you should be able to ping the router.