<td>Turns Full Duplex mode on or off. This option is available only on the RS485 device.</td>
<td>Turns Full Duplex mode on or off. This option is available only on the RS485 device.</td>
</tr>|}}
</tr>|}}
Line 141:
Line 141:
<td>Stop bits</td>
<td>Stop bits</td>
<td>1 | 2; default: <b>1</b></td>
<td>1 | 2; default: <b>1</b></td>
−
<td>Stop bits sent at the end of every character allow the receiving signal hardware to detect the end of a character and to resynchronise with the character stream. Electronic devices usually use one stop bit. Two stop bits are required if slow electromechanical devices are used.</td>
+
<td>Stop bits sent at the end of every character allow the receiving signal hardware to detect the end of a character and to resynchronize with the character stream. Electronic devices usually use one stop bit. Two stop bits are required if slow electromechanical devices are used.</td>
</tr>
</tr>
<tr>
<tr>
Line 166:
Line 166:
<tr>
<tr>
<td>Full Duplex</td>
<td>Full Duplex</td>
−
<td>off | on; default: <b>off</b></td>
+
<td>off {{!}} on; default: <b>off</b></td>
<td>Turns Full Duplex mode on or off. This option is available only on the RS485 device.</td>
<td>Turns Full Duplex mode on or off. This option is available only on the RS485 device.</td>
</tr>|}}
</tr>|}}
Line 238:
Line 238:
<tr>
<tr>
<td>Full Duplex</td>
<td>Full Duplex</td>
−
<td>off | on; default: <b>off</b></td>
+
<td>off {{!}} on; default: <b>off</b></td>
<td>Turns Full Duplex mode on or off. This option is available only on the RS485 device.</td>
<td>Turns Full Duplex mode on or off. This option is available only on the RS485 device.</td>