Difference between revisions of "802.11r WiFi roaming configuration example"
From Teltonika Networks Wiki
(Created page with "11") |
|||
| Line 1: | Line 1: | ||
| − | + | ==Introduction== | |
| + | This article provides a basic configuration example of WiFi roaming. | ||
| + | |||
| + | ==Prerequisites== | ||
| + | * Main gateway with WAN access (Any RUTOS router. RUTXR1 is used in this example) | ||
| + | * Access Points (Any WiFi-capable RUTOS device. RUTX11 (Router 1) and RUT955 (Router 2) are used in this example) | ||
| + | * All devices on <b><i>R_00.02.05.1</i></b> or newer firmware. Legacy firmware is not supported. | ||
| + | |||
| + | Before you start configuring the router <b>turn on "Advanced WebUI" mode</b>. You can do that by clicking the "Basic" button under "Mode", which is located at the top-right corner of the WebUI. | ||
Revision as of 04:17, 26 September 2024
Introduction
This article provides a basic configuration example of WiFi roaming.
Prerequisites
- Main gateway with WAN access (Any RUTOS router. RUTXR1 is used in this example)
- Access Points (Any WiFi-capable RUTOS device. RUTX11 (Router 1) and RUT955 (Router 2) are used in this example)
- All devices on R_00.02.05.1 or newer firmware. Legacy firmware is not supported.
Before you start configuring the router turn on "Advanced WebUI" mode. You can do that by clicking the "Basic" button under "Mode", which is located at the top-right corner of the WebUI.
