Cumulocity Configuration: Difference between revisions

From Teltonika Networks Wiki
No edit summary
No edit summary
Line 360: Line 360:
{{Template: trademark disclaimer}}
{{Template: trademark disclaimer}}
-->
-->
[[Category:IoT]]

Revision as of 13:31, 25 August 2020

Main Page > General Information > Configuration Examples > Third party services > IoT platforms > Cumulocity Configuration

Cumulocity IoT is a cloud-based, real-time IoT management platform that's also compatible with Teltonika-Networks devices.

Introduction

This article contains step-by-step instructions on how to set up a Cumulocity server and register a Teltonika-Networks device on it.

Basic setup

Basic setup consists of:

  1. Creating a Cumulocity account
  2. Configuring Cumulocity on a Teltonika-Networks device
  3. Registering the device on your Cumulocity server

Create an account


First of all, you will need to set up your Cumulocity environment (server).

  • Register an account on Cumulocity.
  • Wait a few minutes after the registration and open your email account. You should have received an email with the subject 'Welcome to Cumulocity IoT'. Open the email and click 'Login to Cumulocity IoT'.
  • Upon a successful login you should be redirected to the Cumulocity Cockpit.

Configure a device


Set up Cumulocity on your Teltonika-Networks device.

  • Log in to your device's WebUI.
  • Go to Services → Package Manager and install Cumulocity.
  • Go to Services → Cloud Solutions → Cumulocity and configure it as follows.
    1. Enable Cumulocity
    2. Specify your Cumulocity server's address in the 'Server Address' field.
    3. Set a connection frequency interval (at least 1 minute).
    4. Click 'Save & Apply'.

Register a device


Register your Teltonika-Networks device on Cumulocity.

  • Find the 'Application switcher' in the top-right corner of the Cumulocity dashboard and go to 'Device management'.
  • Then expand the 'Devices' tab in left-hand menu, go to 'Registration' and click 'Register device'.
  • Complete the registration.
    1. Choose 'General device registration'.
    2. Enter your device's serial number into the 'Device ID' field. The serial number can be found on the device's housing, box or in the WebUI, Status → System page.
    3. Click 'Next'.
  • If the device connects successfully, you should see an indication similar to the one below. Click 'Complete' to finish the registration.