Template:Networking tsw1xx manual powering options: Difference between revisions

Revision as of 16:08, 28 November 2022

This chapter contains information on powering options supported by {{{name}}} switch.

The switch has a pin power socket and can be powered by a VDC power supply unit (PSU). Refer to the image below for the power socket's pinout information:

Power socket

{{Template: Networking_{{{series}}}_manual_power_socket_pinout | name = {{{name}}} }}

[[Category:{{{name}}} Manual]]

@@ Line 20: / Line 20: @@
 <b>{{{name}}} Batch 001 onwards:</b> use UTP (Unshielded) cable only when connecting non-Active PoE (non-803.3af/at) equipment or make sure that these devices support voltages, provided by TSW100 PSU.
   | TSW101 =
+}}
+{{#switch:{{{name}}}
+| TSW100|TSW101= ==Disclaimer: {{{name}}} and Passive PoE devices==
+There are a couple of options to stay safe when using {{{name}}} '''Active PoE''' with devices that only support '''Passive PoE''':
+* Connect {{{name}}} and Passive PoE device only via non-PoE Ethernet ports (for example, '''do not''' use {{{name}}} PoE ports with '''LAN1''' ports on Teltonika devices).
+* If there is a need to use '''LAN1''' port on the end device, make sure that {{{name}}} and the end device are '''powered from different voltage sources''' (for example, power both devices from different PSUs, or different batteries).
 }}
 [[Category:{{{name}}} Manual]]