RUT230 Powering Options
RUT230 {{Template:powering_intro}
Power socket
The router has a 4 pin power socket and can be powered by a 9-30 VDC power supply unit (PSU). Refer to the figure below for the power socket's pinout information:
Passive PoE
Depending on your network architecture you can use the LAN port to power the device. This feature is available from hardware revision 0007 and batch number 0010 (you can check this information in the router's WebUI, Status → Device section).
Though the device can be powered over an Ethernet port it is not compliant with the IEEE 802.3af-2003 standard. Therefore, powering the device from an IEEE 802.3af-2003 power supply will damage the device as it is not rated for input voltages of the PoE standard.
The device is also not compliant with the IEEE 802.3at standard, meaning it can't power other devices over Ethernet.
| Pin | Signal ID | T568A Color | T568B Color | Pins on plug face (socket is reversed) |
| 1 | TX+ |  white/green stripe |
white/orange stripe |
|
| 2 | TX- |  green solid |
 orange solid | |
| 3 | RX+ |  white/orange stripe |
white/green stripe | |
| 4 |  blue solid |
blue solid | ||
| 5 | 7 - 30 VDC |  white/blue stripe |
white/blue stripe | |
| 6 | RX- | orange solid |
green solid | |
| 7 | GROUND |  white/brown stripe |
white/brown stripe | |
| 8 | GROUND |  brown solid |
brown solid |
Simultaneous powering
The device can also be powered from a power socket and over Ethernet simultaneously. The power socket has higher priority meaning that the device will draw power from the power socket as long as it is available.
When the device is switching from one power source to another it loses power for a fraction of a second and may reboot. The device will function correctly after the reboot.