RUT230 QoS

Summary

With QoS you can prioritize network traffic selected by addresses, ports or services. This chapter is an overview of the QoS function in RUT routers.

The information in this page is updated in accordance with the RUT2XX_R_00.01.11.3 firmware version.

General settings and Interfaces

The General settings section is used to enable or disable all QoS functionality and the Interfaces section allows you to set up bandwidth limits for specified network interfaces.

GENERAL SETTINGS
field name	value	description
Enable	yes | no; Default: no	Toggles QoS functionality ON or OFF
INTERFACES
Interface	WAN | LAN | PPP; Default: WAN	Interface that the rule applies to
Enable	yes | no; Default: no	Toggles the rule ON or OFF
Calculate overhead	yes | no; Default: no	Decreases upload and download ratio to prevent link saturation
Half-duplex	es | no; Default: no	Enables data transmission in both directions on a single carrier
Download speed (kbit/s)	integer; Default: 1024	Specifies maximum download speed for the specified interface
Upload speed (kbit/s)	integer; Default: 128	Specifies maximum upload speed for the specified interface

Classification Rules

field name	value	description
Target	Priority | Express | Normal | Low; Default: WAN	Target for which the rule will be applied
Source host	All | ip; Default: All	Host from which data will be transmitted
Destination host	All | ip; Default: All	Host to which data will be transmitted
Protocol	All | TCP | UDP | ICMP | -- custom --; Default: All	Data transmission protocol
Ports	All | integer [0..65535]; Default: 22,53	Port(s) that will be used for transmission. You can enter multiple ports by separating them by commas (',')
Number of bytes	integer; Default: " "	The maximum number of bytes for the connection