Template:Networking rutos manual leds
This page contains information the different types of LEDs and their behaviour on a {{{name}}} router.
Power LED
The power LED is located on the bottom left corner of the front panel, just under the power connector.
[[File:{{{file_power}}}|400px]]
It indicates whether the router is powered on or not
| State | Description |
|---|---|
| LED turned on | Router is powered on |
| LED turned off | Router is not powered on |
Ethernet port LEDs
There are two LEDs located at the top of each Ethernet port.
[[File:{{{file_ethernet}}}|400px]]
They provide information on the current states of the Ethernet ports. Each port has two LEDs:
- Orange - 10/100 Mbps connection
- Green - 1000 Mbps connection
Below is an explanation on the behaviours of green and orange LEDs.
| State | Description |
|---|---|
| LED on | A data connection on the port is operational (cable plugged in, end device visible, no data is being transferred). |
| LED off | No data connection on the port is operational (no cable, bad cable or end device not visible for some other reason (such as damaged network card)). |
| LED blinking | Connection established and data is being transferred over this port. |
{{#ifeq: {{{mobile}}} | 1 |
Mobile network type LEDs
The mobile network type LEDs are located just above the {{{type_sim}}} holder.
[[File:{{{file_net_type}}}|400px]]
They display which type of Internet connection is currently active.
| Action | Description |
|---|---|
| 3G LED turned on | Device is connected to a 3G network. |
| 4G LED turned on | Device is connected to a 4G network. |
| 3G blinking | Device is connected to a 3G network but hasn't received an IP address. |
| 4G blinking | Device is connected to a 4G network but hasn't received an IP address. |
| 3G & 4G LEDs blinking at the same time every 500 ms | No SIM card or incorrect PIN. |
| 3G & 4G LEDs turns on and off in a sequence one after the other | The device is attempting to connect to a mobile network operator. |
Mobile signal strength indication LEDs
The mobile signal strength indication LEDs are located just above the {{{strength_sim}}} holder.
[[File:{{{file_signal}}}|400px]]
The number of lit up LEDs represents a different mobile signal strength (RSSI) value in dBm.
| No. of lit up LEDS | Signal strength |
|---|---|
| 0 | ≤ -111 dBm |
| 1 | -110 dBm to -97 dBm |
| 2 | -96 dBm to -82 dBm |
| 3 | -81 dBm -67 dBm |
| 4 | -66 dBm to -52 dBm |
| 5 | ≥ -51 dBm |
[[Category:{{{name}}} Manual]]