TSW110 LEDs
Revision as of 09:35, 8 October 2020 by Dziugas (talk | contribs) (Protected "Draft:TSW110 LEDs" ([Edit=Allow only administrators] (indefinite) [Move=Allow only administrators] (indefinite)))
Main Page > TSW Switches > TSW110 > TSW110 Manual > TSW110 LEDs
This page contains information the different types of LEDs and their behaviour on a TSW110 device.
Power LED
The power LED is located on the bottom left corner of the front panel, just under the power connector.
It indicates whether the device is powered on or not.
| State | Description |
|---|---|
| LED turned on | Device is powered on. |
| LED turned off | Device is not powered on. |
Ethernet port LEDs
There are two LEDs located at the top of each Ethernet port.
They provide information on the current states of the Ethernet ports. Each port has two LEDs:
- Orange - 10/100 Mbps connection
- Green- 1000 Mbps connection
Below is an explanation on the behaviours of green and orange LEDs.
| State | Description |
|---|---|
| LED on | A data connection on the port is operational (cable plugged in, end device visible, no data is being transferred). |
| LED off | No data connection on the port is operational (no cable, bad cable or end device not visible for some other reason (such as damaged network card). |
| LED blinking | Connection established and data is being transferred over this port. |