Mobile Parameters to HTTP Server

From Teltonika Networks Wiki
Revision as of 10:44, 6 April 2023 by Jan.pena (talk | contribs)

Introduction

Mobile parameters are needed to measure signal features that can be acquired using gsmctl commands. However, there is no available command to check/display all of the desired details.

With that said, a custom script is needed to show them using one command. This article provides step-by-step instructions on how to write the script, programs that are required, and how to run it.


  • First you want to make sure that you have ADVANCED mode enabled. This will allow you to choose from a larger variety of settings.

Prerequisites

For this particular configuration you will need:

  • A Gateway or a Router with GSM (RUTX14 is being used in the example)
  • 1 SIM card
  • 1 PC
  • HTTP Server (Hercules)

Preparation

  • Prepare RUTX14, power up the device, insert the sim card, check that mobile interface is active and working. SIM1, PWR and signal strength indicators should light up.

Network -> Interfaces should look similar to this:

Retrieved from "https://wiki.teltonika-networks.com/index.php?title=Mobile_Parameters_to_HTTP_Server&oldid=106472"