RUT140 IGMP Proxy

From Teltonika Networks Wiki
Revision as of 09:07, 4 April 2024 by Vainius.l (talk | contribs) (Created page with "{{Template: Networking_rutos_manual_igmp_proxy <!------------------------DEVICE-----------------------> | name = RUT140 | series = RUT14X }}")

(diff) ← Older revision | Approved revision (diff) | Latest revision (diff) | Newer revision → (diff)
Main Page > RUT Routers > RUT140 > RUT140 Manual > RUT140 WebUI > RUT140 Network section > RUT140 IGMP Proxy

The information in this page is updated in accordance with firmware version RUT14X_R_00.07.10.

Summary

IGMPproxy is a simple dynamic Multicast Routing Daemon using only IGMP signalling (Internet Group Management Protocol). IGMP proxy enables the device to issue IGMP host messages on behalf of hosts that the device discovered through standard IGMP interfaces. The device acts as a proxy for its hosts.

Routing is done by defining an "upstream" interface on which the daemon act as a normal Multicast client, and one or more "downstream" interfaces that serves clients on the destination networks.

This chapter of the user manual provides an overview of the IGMP Proxy page in RUT140 devices.

Note: IGMP Proxy is additional software that can be installed from the System → Package Manager page.


If you're having trouble finding this page or some of the parameters described here on your device's WebUI, you should turn on "Advanced WebUI" mode. You can do that by clicking the "Advanced" button, located at the top of the WebUI.

General Settings

Field Value Description
Enable off | on; default: off Enables the IGMP Proxy service.
Quickleave off | on; default: on If enabled, the daemon will send a Leave IGMP message upstream as soon as it receives a Leave message for any downstream interface.

Routing Interfaces

By default, there are no routing interfaces configured. To create one, press Add.

Routing Interface Configuration


This section is used to configure the create routing interface.

Field Value Description
Direction Upstream | Downstream; default: Upstream Interface is called "upstream" if it's in the direction of the root of the multicast tree. An IGMP forwarding router must have exactly one upstream interface configured..
Interface network interface; default: lan The name of the interface the settings are for.
Firewall firewall zone; default: lan Name of a firewall zone this interface belongs to.
Networks ip/netmask; default: none A list of CIDR-masked Network entries to control what subnets are allowed to have their multicast data proxied. Multiple subnets can be configured or 0.0.0.0/0 specified to allow any network. Option can be omitted entirely to only allow same network as configured on interface.