LAN Traffic Splitting Using Advanced Static Routing Rules

From Teltonika Networks Wiki

Introduction

This article provides a guide on how to separate mobile data traffic within a LAN by using advanced static routing rules. These configurations are specifically made for RUTX12.


  • First you want to make sure that you have ADVANCED mode enabled. This will allow you to choose from a larger variety of settings.


Prerequisites

For this particular configuration you will need:

  • A Router with 2xLTE modules (RUTX12 is being used in the example)
  • 2 SIM cards
  • 2 PCs in the same LAN network

Preparation

  • Prepare RUTX12, power up the device, insert two sim cards, check that both are active and working. SIM1, SIM2, PWR and signal strength indicators should light up.
  • Access the router through WEBUI, go to Network -> Interfaces, make sure that both MOB1S1A1 and MOB2S1A1 interfaces are running (Status = Running). You should also be able to see their Ip addresses.
  • Make sure that you have ADVANCED mode enabled. This will allow you to choose from a larger variety of settings.


Network -> Interfaces should look similar to this:

Configuration

1. Go to Network –> Interface -> edit MOB2S1A1 -> Advanced settings -> Set IP4table to 10. Click save and apply.

2. Go to Network -> Routing -> Advanced Static Routes -> Add new instance of Routing table. Table ID can be chosen freely, however, it later on must match in the routing rules configuration. E.G TableID = 10 and set the Name of the Table, E.G Name of Table = Example.

3. Click the edit button on next to the created routing table:

4. Configure the Static route in the following manner and click save and apply:

  • interface: LAN
  • Name: Example
  • Target: 192.168.1.0
  • IPV4-Netmask: 255.255.255.0
  • Leave everything other blank
  • Add the route.


Retrieved from "https://wiki.teltonika-networks.com/index.php?title=LAN_Traffic_Splitting_Using_Advanced_Static_Routing_Rules&oldid=85312"