The configuration testing is straight forward, you will need to execute command '''cat /sys/bus/w1/devices/<device_name>/w1_slave''' you should see the data from your sensor in the CLI output, keep in mind that the output entirely depends on the 1-Wire sensor used, so most likely you will see different outup. And if you will be using a similar 1-Wire device to '''DS9092''' you will need to touch and hold the key for a few seconds until you would see the slave device.
+
+
'''The example output:'''
+
[[File:Networking trb141 configuration 1 wire cli commands test v1.png|border|class=tlt-border|1100px]]