Line 116: |
Line 116: |
| | | |
| '''''Note:''''' Do not use WebUI to change this setting. It has to be done via AT commands. | | '''''Note:''''' Do not use WebUI to change this setting. It has to be done via AT commands. |
− |
| |
− | ====Setting the device to the airplane mode====
| |
− | ----
| |
− |
| |
− | To set the device to the airplane mode, run this command:
| |
− | <pre>gsmctl -A 'AT+CFUN=0'</pre>
| |
− | '''This process may take up to one minute''', and when it's done, the modem will reply '''OK''' in the terminal.
| |
| | | |
| ====Finding the serving cell details==== | | ====Finding the serving cell details==== |
Line 160: |
Line 153: |
| The explanation for the last 3 measurements can be found on our [[Mobile_Signal_Strength_Recommendations|Mobile signal strength recommendations]] page. | | The explanation for the last 3 measurements can be found on our [[Mobile_Signal_Strength_Recommendations|Mobile signal strength recommendations]] page. |
| '''From these outputs, the most fitting cell should be picked, and its EARFCN and PCI value should be noted.''' | | '''From these outputs, the most fitting cell should be picked, and its EARFCN and PCI value should be noted.''' |
| + | |
| + | ====Setting the device to the airplane mode==== |
| + | ---- |
| + | |
| + | To set the device to the airplane mode, run this command: |
| + | <pre>gsmctl -A 'AT+CFUN=0'</pre> |
| + | '''This process may take up to one minute''', and when it's done, the modem will reply '''OK''' in the terminal. |
| | | |
| ====Locking to a selected cell==== | | ====Locking to a selected cell==== |